3D Printed Grounding Strap for Low SWaP Electrical Failure Mitigation during Spaceflight Missions
The Future of Electronics RESHAPED 2026 Berlin
22 October 2026
Berlin, Germany
Estrel Berlin Hotel & Convention Center:
Sonnenallee 225, 12057 Berlin
Lunar missions require high-TRL technologies that meet stringent material, mechanical thermal and electrical requirements. Printed electronics can be a boon to many spaceflight applications (e.g., sensors, antennas, interconnects, detectors), offering structures uniquely available via additive manufacturing as well as coveted reductions in size, weight and power (SWaP). Here, a conductive grounding strap was fabricated and tested with the south pole lunar surface environment in mind. By printing a grounding strap on the inside of the battery wall, replacing a traditional grounding strap component used to mitigate electrical failures due to sudden current jumps, internal volume and mass were saved. Testing included adhesion testing to the battery wall substrate (ultem), outgassing testing, thermal shock and electrical characterization. Adhesion testing of the conductive ink to ultem yielded strong adhesion results using ASTM standards. Outgassing testing showed reasonable results for a general spaceflight environment, and an initial thermal shock test was performed to assess the response of the printed conductor to rapid temperature transitions and provided preliminary evidence regarding its thermal survivability. Ultimately, the printed grounding strap met the 1.5 A electrical requirement and reduced the mass of the component in the assembly by 94%. Further thermal cycling testing is needed as well as a suborbital test flight proof-of-concept experiment to qualify the grounding strap design for implementation for a long-term spaceflight mission.
Watch the 5-minute excerpt from the talk
Video highlights and other talks by this speaker appear here.


