top of page

Emilio Gutierrez-Partida

PicoQuant GmbH

* All members of the platform can watch the entire presentation.

 

Please register to become a member.

Emilio Gutierrez-Partida | PicoQuant GmbH: Can TRPL cut perovskite manufacturing cost by probing films before a full device exists?

11:21 - 13:00

Other snippets from this talk

Summary of the clip:

Can TRPL cut perovskite manufacturing cost by probing films before a full device exists?

Time-resolved photoluminescence has the advantage that you do not need a full device. You can probe your sample at all the different stages of your device creation and save costs because you can know earlier how good your film is going. The method is still being implemented and is kind of a new method.

An entry level for time-resolved photoluminescence techniques on characterization in inline systems is emerging. Inline procedures can use green light or red light to indicate the good or the bad sample. The biggest strength right now of this system specifically would be for R&D purposes in the industry to get a competitive advantage against other companies.

Typical data accumulation time is a combination of factors. You can take images as fast as in one minute if it is for your research group presentation, or you can leave them overnight to have the best quality to publish on the paper. These images shown were taken in 5 to 10 minutes each, something like that, for both carrier diffusion and time-resolved photoluminescence.

In this short video, you can learn:
* Time-resolved photoluminescence does not need a full device, so samples can be probed at different stages of device creation.
* Earlier knowledge of film quality can save costs, although the method is still being implemented.
* Image acquisition can be as fast as one minute for presentations or overnight for publication-quality data, with shown images at 5 to 10 minutes each.

📋 **Clip Abstract** Time-resolved photoluminescence offers an advantage because no full device is needed, allowing samples to be probed at all stages of device creation and costs to be saved by knowing earlier how good a film is. The technique is still being implemented, with inline entry-level characterization emerging and data accumulation times ranging from one minute to overnight, while shown images took 5 to 10 minutes each.

About the speaker:
* Speaker: Emilio Gutierrez-Partida
* Company: PicoQuant GmbH
* Event: nnovation Festival: Additive, Printed, Sustainable Electronics, MicroLEDs and AR/VR Displays, Perovskites | July 2026
* Location: Online Platform

Annual access to our onsite event(s), all online events and a library featuring over 1800 presentations (recordings + PDF) across all our onsite and onsite events and technology areas. Join us and over 2000 members from around the world now.
Explore and join now --> https://www.techblick.com/

#TimeResolvedPhotoluminescence, #CarrierDiffusionImaging, #InlinePhotoluminescence, #PerovskiteFilmQuality, #PerovskitePhotovoltaics, #SolarCellCharacterization

This is a highlight of the presentation:

Spatially Resolved TRPL Imaging of Laser-Patterned Perovskite Solar Mini Modules

Innovation Festival: Additive, Printed, Sustainable Electronics

Innovation Festival: MicroLEDs and AR/VR Displays

46213

Online Platform

Organised By:

TechBlick

TechBlick and MicroLED Industry Association

More Highlights from the same talk.

05:26 - 07:46

Why is photoluminescence lifetime shorter right next to a laser pattern line?

Why is photoluminescence lifetime shorter right next to a laser pattern line?

Before measuring decays, the emission wavelength must be selected. A band gap around 1.58 electron volts was assumed, but the spectrum revealed an unexpected peak, later identified as stray light from a room lamp. A sample chamber avoids turning off room lights. The microscope can also measure spectra, allowing exact decay wavelength selection at 790 nanometers.

At 790 nanometers, two points of interest were selected: one close to the pattern line and one away from it. The closer point showed a faster TRPL decay and shorter lifetime; farther away, lifetime was longer. A microscope also enables imaging, mapping lifetime over different areas to visualize how it falls closer to pattern lines.

In another map, the pattern lines are the most luminescent part. Such data support a specific analysis called differential decay time, used in Maxim's paper. The results shown here are not inside that paper because it was submitted before these measurements; they are basically a continuation of the analysis.

In this short video, you can learn:
* A spectrum must be measured first to select the TRPL wavelength, here 790 nanometers, and stray room-lamp light can contaminate that spectrum.
* TRPL decays close to the laser pattern line were faster with shorter lifetime, while points farther away had longer lifetime.
* Lifetime maps can show lower lifetime nearer pattern lines or, in another case, pattern lines as the most luminescent part.

📋 **Clip Abstract** TRPL imaging selects a spectrum, then a 790-nanometer decay wavelength, to compare points near and far from a laser pattern line. The closer point decays faster with shorter lifetime, and lifetime maps reveal different effects, including pattern lines as the most luminescent part in another case.

About the speaker:
* Speaker: Emilio Gutierrez-Partida
* Company: PicoQuant GmbH
* Event: nnovation Festival: Additive, Printed, Sustainable Electronics, MicroLEDs and AR/VR Displays, Perovskites | July 2026
* Location: Online Platform

Annual access to our onsite event(s), all online events and a library featuring over 1800 presentations (recordings + PDF) across all our onsite and onsite events and technology areas. Join us and over 2000 members from around the world now.
Explore and join now --> https://www.techblick.com/

#TRPLDecay, #LifetimeMapping, #LaserPatternLine, #DifferentialDecayTime, #PerovskiteSolar, #PhotoluminescenceImaging


About this talk

→ Spatially Resolved TRPL Imaging of Laser-Patterned Perovskite Solar Mini Modules · Emilio Gutierrez-Partida · TechBlick Innovations Festival July 2026

More Snippets
CONTACT US

KGH Concepts GmbH

Mergenthalerallee 73-75, 65760, Eschborn

+49 17661704139

admin@techblick.com

TechBlick is owned and operated by KGH Concepts GmbH

Registration number HRB 121362

VAT number: DE 337022439

  • LinkedIn
  • YouTube

Sign up for our newsletter to receive updates on our latest speakers and events AND to receive analyst-written summaries of the key talks and happenings in our events.

Thanks for submitting!

© 2026 by KGH Concepts GmbH

bottom of page