Khaled Ahmed | Intel: Why do state-of-the-art OLED products deliver only about half the power efficiency achieved in laboratory devices?
09:55 - 12:11
Other snippets from this talk
Summary of the clip:
Why do state-of-the-art OLED products deliver only about half the power efficiency achieved in laboratory devices?
The analysis compares reported OLED power efficiency for red, green and blue against laboratory OLED devices. A data envelope, collected from literature over roughly the past 20 years but not shown for clarity, contains all reported values underneath it. This envelope exposes a gap: state-of-the-art product OLEDs reach only about half the efficiency that laboratory OLEDs demonstrate. The question is why that gap persists when the higher laboratory efficiency is reportedly achievable.
One suspect is a trade-off between high efficiency and OLED lifetime. This is described as a guess: product requirements may force lower efficiency to maintain a higher lifetime or the high brightness needed. The previous slide indicates OLED efficiency is saturating for a reason. Even though higher efficiency potential exists, actual products do not show it, so the limitation remains visible in product data.
The limitation was observed and published at SID 2021. It links the product-versus-laboratory efficiency gap to a possible lifetime trade-off rather than to an absence of efficiency potential. The envelope shows what literature has reported; products remain at about half. Thus the saturation is not because higher efficiency is unavailable in the laboratory, but because product constraints appear to keep performance below that envelope.
In this short video, you can learn:
* A literature envelope covering roughly 20 years of OLED data shows product power efficiency at about half laboratory values.
* The suspected cause is a trade-off between high efficiency and OLED lifetime, possibly driven by product lifetime or brightness requirements.
* The limitation was published at SID 2021, and OLED efficiency is described as saturating despite available higher-efficiency potential.
đź“‹ **Clip Abstract** Reported OLED power efficiency for red, green and blue is compared with laboratory devices using a literature envelope spanning roughly 20 years. The envelope reveals product OLEDs at about half laboratory efficiency, with a suspected efficiency-versus-lifetime trade-off and product brightness requirements explaining the saturation.
About the speaker:
* Speaker: Khaled Ahmed
* Company: Intel
* Event: Displays & Lighting 2021: Innovations & Market Trends
Join TechBlick to learn about the cutting edge in the display industry
https://www.techblick.com/
#OLEDPowerEfficiency, #EfficiencyLifetimeTradeOff, #LaboratoryOLEDEnvelope, #ProductOLEDGap, #OLEDDisplays, #DisplayMetrology
This is a highlight of the presentation:
Fundamental Challenges in Micro LED Display Technology
More Highlights from the same talk.
06:06 - 07:43
Why does display power draw, not just screen size, decide whether mobile platforms can close the battery gap?
Why does display power draw, not just screen size, decide whether mobile platforms can close the battery gap?
Across roughly seven years of actual product releases, surveyed battery capacity is plotted against device power consumption. The black dots represent how much power the battery can supply for 24-hour operation. The data show a gap between power demand and battery power supply, and that gap increases over time as more functions and features are added.
The battery gap is not driven solely by making the display bigger; added functions and features also consume power. Displays consume about 70% of the overall power of a platform such as a smartphone or a laptop. That share means display power draw must be addressed as the gap between battery supply and device demand increases.
Because the display consumes about 70% of overall platform power, decreasing that power consumption by half would have a huge impact. The measured gap between battery power supply for 24-hour operation and device power demand is increasing over time. Addressing display power directly targets the largest share identified in the data, while added functions and features continue to raise demand.
In this short video, you can learn:
* Surveyed battery capacity for 24-hour operation falls short of device power demand, and the gap grows across product releases.
* Displays consume about 70% of overall platform power in smartphones and laptops.
* Halving display power consumption would have a huge impact on the platform battery gap.
đź“‹ **Clip Abstract** Measured product data show a widening gap between battery capacity for 24-hour operation and device power consumption over roughly seven years. Because displays use about 70% of platform power, halving display consumption would have a huge impact on that gap.
About the speaker:
* Speaker: Khaled Ahmed
* Company: Intel
* Event: Displays & Lighting 2021: Innovations & Market Trends
Join TechBlick to learn about the cutting edge in the display industry
https://www.techblick.com/
#BatteryCapacityGap, #DisplayPowerConsumption, #24HourOperation, #SmartphonePlatformPower, #MicroLEDDisplays, #MobileDisplayPower
20:03 - 22:15
How many nines of wafer and transfer yield does a zero-defect-pixel microLED display actually need?
How many nines of wafer and transfer yield does a zero-defect-pixel microLED display actually need?
Published 2020 SID simulations map wafer die yield against transfer yield for roughly 50% display line yield, meaning half the started displays meet the defect specification. For zero defective pixels, the curve demands almost seven nines—1, 2, 3, 4, 5, 6, 7. Relaxing the criterion to 10 defective pixels improves the requirement, but not by much: it remains six nines.
The right-hand simulations introduce redundancy of three: every pixel contains three red micro-LEDs, three blue micro-LEDs and three green micro-LEDs. The calculation compares required wafer die yield with required transfer yield for 80% display line yield at Quad HD resolution, a high-end example. With that redundancy, zero defective pixels need only three nines for both die yield and transfer yield to achieve display yield.
These are simulations, yet the comparison exposes the order-of-magnitude difference that defect management must bridge. The no-redundancy case sits near six to seven nines; the redundancy-three case sits near three nines for wafer die yield and transfer yield. The result frames defect management as the second fundamental challenge: the industry must resolve both wafer-level die yield and transfer yield together, not one in isolation.
In this short video, you can learn:
* Published SID 2020 simulations show zero defective pixels need almost seven nines of wafer die yield and transfer yield for about 50% display line yield.
* Relaxing to 10 defective pixels reduces the requirement only to six nines.
* Redundancy of three red, blue and green micro-LEDs per pixel lowers the zero-defect requirement to three nines at 80% line yield for Quad HD.
đź“‹ **Clip Abstract** The clip quantifies defect-management targets for microLED displays using 2020 SID simulations: zero defective pixels demand almost seven nines of wafer die and transfer yield at roughly 50% line yield, while 10 defective pixels still need six nines. Adding redundancy of three red, blue and green micro-LEDs per pixel changes the requirement to three nines for both yields at 80% line yield for Quad HD.
About the speaker:
* Speaker: Khaled Ahmed
* Company: Intel
* Event: Displays & Lighting 2021: Innovations & Market Trends
Join TechBlick to learn about the cutting edge in the display industry
https://www.techblick.com/
#WaferDieYield, #TransferYield, #TriplePixelRedundancy, #ZeroDefectivePixels, #MicroLEDDisplays, #DisplayManufacturing
18:21 - 20:04
Why does pick-and-place die transfer collapse for laptop-sized microLED displays?
Why does pick-and-place die transfer collapse for laptop-sized microLED displays?
The clip frames mass transfer as a production gate: microLEDs must move from red, green and blue wafers to a backplane. It cites reports that about $4 billion or more has been spent worldwide on microLED technologies, with everybody racing. The speaker’s normalized calculation compares display-per-hour throughput against display size, normalized to the value at 2-inch, to test transfer methods.
Pick-and-place is acceptable up to roughly a 2-inch display, but the throughput then falls rapidly. For a 15.6-inch laptop display, the calculation shows an almost 100x decrease. That is the collapse the hook targets: pick-and-place, pick-and-bond or whatever it is called is not cost-effective for large displays based on these calculations.
The contrast is a massive transfer method: with truly massive transfer, display throughput would be pretty much the same over various display sizes. The argument therefore places the production milestone on introducing a mass transfer method, not on incremental pick-and-place refinement. The red, green and blue wafer-to-backplane step remains the fundamental challenge for production.
In this short video, you can learn:
* Reported worldwide spending on microLED technologies is about $4 billion or more, reflecting a race to production.
* Normalized throughput for pick-and-place falls almost 100x from a 2-inch display to a 15.6-inch laptop display.
* A truly massive transfer method would keep display throughput roughly the same across display sizes, unlike pick-and-place or pick-and-bond.
đź“‹ **Clip Abstract** Mass transfer from red, green and blue wafers to a backplane is framed as a production milestone for microLED displays, against reported worldwide spending of about $4 billion or more. Normalized throughput calculations show pick-and-place holding to about 2-inch displays but dropping almost 100x for a 15.6-inch laptop display, while truly massive transfer would keep throughput roughly the same across display sizes.
About the speaker:
* Speaker: Khaled Ahmed
* Company: Intel
* Event: Displays & Lighting 2021: Innovations & Market Trends
Join TechBlick to learn about the cutting edge in the display industry
https://www.techblick.com/
#MicroLEDMassTransfer, #PickAndPlaceTransfer, #WaferToBackplane, #LaptopDisplayThroughput, #MicroLEDDisplays, #DisplayManufacturing
About this talk
→ Fundamental Challenges in Micro LED Display Technology · Khaled Ahmed · Displays & Lighting: Innovations & Market Trends 2021


